August 25th, reinstalling the dash, making a speedometer gromet

Hi There,

Won't be a long post today,  in fact I'm going to do two posts today one for the work done on the 25th and one for today the 27th.

The parts came on Monday but it felt a little like the Christmas when I was five and Santa forgot the bullets for my 'Fanner Fifty',  I got the hoses but the speedometer grommet wasn't in the shipment and I had been waiting on this piece so I could put the dash back together.  Well, it was either wait another week or so to reorder it or try to make one.  I'll let you be the judge of how it came out but I think it would take a pretty close inspection to see it wasn't OEM.

After I installed the grommet then I could proceed with the dash top and so forth.  I'll let the pictures do the talking from here:




 
That's it for the 25th.

Cheers,

Lynn

3 hrs

Comments

Post a Comment

Popular posts from this blog

Introducing Scott's 1970 Primrose OTS

Image
Hi There, This will be a blog discussing the work I am going to be doing on Scott's E Type Jaguar.  Scott bought this car in 1988 reportedly with 29,341 original miles on the odometer.  He is the second owner of this well documented car which now has 38.083 miles on it.   Scott tells me that the original owner bought it in September of 1970 from Continental Motors in St. Louis, Mo. after she passed away the car sat for three years till it was purchased by the second owner who replaced the left rocker panel and repainted the car in it's original primrose. Scott bought the car in August of '88 as a fortieth birthday present for himself and has been it's caretaker since. It appears to be a very original car that has been well maintained over the course of years with Scott keeping meticulous records of the service done on the car.  As with most cars of this vintage there are a few issues but in general the car appears to be very well preserved with no appa...
Read more

Day 11, Transmission fluid

Image
 Hi Ya'll, Very short day and a hot one to boot!  Got some parts ordered today from SNG, new coolant hoses, a couple of grommets for the fire wall and an 'O'ring for the heater control valve.  The turn signal activator bracket is also in and was shipped today, as I've mentioned this is a critical piece as it keeps the locking pin that holds the steering column in.  Work today consisted of lowering the exhaust system so I could get the transmission drain bolt out, draining the transmission and refilling with Redline MT90.  If you search Jag Lovers you'll find that this is considered a vast improvement over standard 90W gear oil and my personal experience has been good with it to, not cheap but the transmission will likely shift better. Looking for the access hole for the trany fill plug I found this 'mouse' hole,  just kidding.  I think that someone drilled this out so that they could install a new speedometer cable or angle drive. Needless to say it wo...
Read more

This and That....

Image
Not an official blog entry just a few things that I took care of over the weekend while waiting for parts that are supposed to arrive today: These pictures are completely out of order but this picture is obviously of the seat bottom on the passenger side.  The rubber diaphragm will need to be replaced in the near future as they have become brittle with time and on the drivers seat the front has cracked/broken off so that it's unsupported.  I used a bit of bailing wire to bodge it and it may hold for a bit longer but suspect it will eventually rip through the rubber diaphragm.   The drivers side after cleaning The floors are very solid under the seats No Rust at all The bottom of the drivers seat with the missing clips, as I mentioned I reenforced this area with a bit of bailing wire but probably should think about replacing the diaphragms in the future The sun-visors where loose and wouldn't tighten up, investigating revealed that a screw that was to long had been us...
Read more